New Product!

T Sportline Tesla Cybertruck "Factory Style" Mud Flaps are designed to look like factory extensions of the wheel arch and side cladding.  This simple DIY bolt-on mud flap kit is an easy way to help protect your Cybertruck while keeping it clean.   

The T Sportline kit is complete, including all 4 mud flaps and body pin fasteners.  The mud flaps require no drilling or screwing or prying into fender gaps!  T Sportline Mud Flaps install using body pin fasteners similar to those used on the factory assemblies.  The mud flaps can be removed and no permanent modifications are necessary.  

Protect your Cybertruck's stainless steel (or wrap / ppf) on doors and rear quarter panels from rock chips and road debris that is thrown up from your tires.  T Sportline Mud Flaps are suitable for use in all harsh weather climates, including extreme heat and below-freezing temperature. 

Looking for a sportier carbon fiber mud flap?  Check our other offering HERE

Specifications:

• Attaches onto Tesla Cybertruck using included body pin fasteners - no drilling or mods required.
• Designed to match the factory wheel arch and side cladding 

What is Included:

• • Set of 4 Factory Style Injection Molded Mud Flaps
  • Attachment hardware

For best installation success, we recommend adding the optional wax and grease removed (cleaning), alcohol wipes (final wipe down of 3m tape mating surfaces on Cybertruck), and adhesion promotor (1 pack is enough to use on each tape attachment location).  

For installation prep, the cleaner the surface, the better.   3m tape adhesion will be most secure if the surface is properly prepped:

1 - Thoroughly wash the factory cladding all around where the mud flaps attached.  Do a great job as this surface is probably filthy.  

2 - Use the wax and grease removed towelette to remove any stubborn road grim, road tar, or grease.   After using the towelette, re-wash the surfaces to remove any reside from the wax and grease remover

3 - Allow the surface to dry completely.  Once dry, pre-fit the mud flap to identify where the 3m attachment tape will mate to the vehicle.  

4 - Use the alcohol wipes to clean the surfaces where the 3m tape will connect.  Allow the surface to totally dry after wiping.

5 - Apply the adhesion promotor to the cleaned attachment surface.  Allow it to try for 5 minutes.

6 - Install mud flap by removing the backing from the 3m tape, line up the mud flap and install.  Press the areas where 3m tape connects to the vehicle.  Hold pressure on each for a few minutes.  Install push pins.

Shipping is calculated at Checkout.

Shipping & Handling charges subject to change without prior notification. PLEASE NOTE THAT INTERNATIONAL SHIPMENTS ARE SUBJECT TO CUSTOMS TAXES/DUTIES, AS CHARGED BY YOUR COUNTRY (THERE ARE NO U.S. CUSTOMS FEES). INTERNATIONAL CUSTOMERS ARE RESPONSIBLE FOR PAYMENT OF THESE FEES. Due to service availability, some international orders may need to be sent to the nearest international airport.